This signal generator uses a precision multiturn potentiometer to generate clean and adjustable current and voltage signals. By turning the potentiometer, you can produce a 0/420 mA current signal and a 010 V voltage signal, with additional flexibility for different ranges. Key benefits Precise, adjustable signal generation through a single precision multiturn potentiometer for both current and voltage outputs Flexible output ranges: current outputs selectable to 020 mA or 420 mA, and voltage output from 0 to 10 V Suitable as a signal source for test benches, calibration routines, and control system debugging Realtime verification of current output with a dedicated display to aid calibration and setup What it outputs Current output: selectable 020 mA or 420 mA Voltage output: 010 V What it can be used for Signal source generation for test benches and instrumentation Valve adjustment and tuning in control loops Inverter control and general control system testing PLC debugging and verification of input channels Instrument testing and LED testing for signal verification Analog transmitter output for calibration and signal tracing Calibration and debugging steps Current display correction Rotate the multiturn potentiometer clockwise to the maximum position Pull the display switch to the right Use a multimeter to measure the actual current output Adjust the potentiometer until the display value matches the measured current Ensure the display value is consistent with the actual current output Notes The device provides a straightforward method to generate and verify 0/420 mA and 010 V signals using a single control element Intended for use in applications requiring precise manual adjustment and verification of current and voltage signal outputs