Instructions for use Inflating instructions: Before inflating the balloon, pull the balloon first to expand the elasticity of the balloon Then inflate, leave about 10cm at the top of the balloon and then inflate the balloon, do not It filled up too quickly. Modeling instructions: It is not easy to do modeling when the balloon is just filled with good air, and it is just filled with good air The ball is very hard, too full of air, you need to pinch a few times with your hand, slightly let off some air, and then soft the balloon It's less likely to explode. Note: Long balloons are difficult for non-professionals to blow up, in order not to affect the use of the build Discuss the purchase of pump with use. Color: Transparent, Black, Brown, Green, Purple, Yellow Size: about 26 cm Product description: There may be a 1% quantity error in the whole package of balloons, and there may be The loss rate of 1%-5%, which is unavoidable in the entire industry, please understand During the balloon production process to prevent the balloon sticking, there will be talcum powder, which may cause gas There is residue on the surface of the ball, this is not dust oh ~ talc and air contact, tide It feels a little dirty after wet, this is not a quality problem!! (Light Color The system will be more obvious) If you care, you can use clean water or wipe with a rag, this will not Affect the use of. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom’s policies and EU Product Safety and Compliance laws.