Bullet Points:1.High Power Generation Efficiency:Using MPPT boost charging technology, it can be started at low preure in a gentle breeze, and the energy is sufficient.2. Long Service Life: Thermally conductive silicone filling and sealing, IP67 protection grade waterproof, dustproof, durable, wear-resistant, anti-circuit oxidation, and lightweight, compact size design.3. High Safety: The Wind Turbine Charge Controller is designed with perfect overcharge protection, reverse connection protection, short circuit protection, high temperature protection and other functions, it is safer and more convenient to use.4. Technology Upgrade: Compared with the traditional PWM charge controller, our Wind Turbine Generator greatly improves the charging capacity, the utilization efficiency of the power generation system, and the energy conversion rate.5. Strong Versatility: Automatically identify 12v 24v voltage, easy to adjust and switch, the Wind Power Charge Controller is suitable for most parts of the world. Description: 1. The controller can control the wind turbine to automatically charge the battery. When the battery is fully charged, the fan will be braked automatically through the internal circuit. When the battery voltage drops to the recovery voltage, the fan will resume charging the battery to protect the battery. fan and battery.2. Modular design makes the performance of the whole system guaranteed to the greatest extent. The rectifier and brake circuit parts of the controller are designed with integrated modules, which are better than the traditional design in terms of heat diipation and reliability.3. Comprehensive waterproof protection. This controller adopts a fully sealed and completely waterproof design, and the protection level has reached IP67 or above. Even if it is placed in water, it can be used normally for a long time, and the stability and reliability are greatly improved. Parameters: 1. Maximum input AC voltage: AC35V;2. Output DC voltage: DC12V / 24V;3. Battery charging cut-off voltage: DC14.5V 0.3V / 29V 0.3V;4. Maximum charging current: 15A (12V) maximum charging current: 10A (24V);5. Wind driven generator speed limit voltage DC14.5V 0.3V, 29V 0.3V;6. Protection level: IP67;7. Static power consumption: 0.008A;8. Bearing power: 2000W;9. Maximum bearing wind speed: lvl.12;10. Working temperature: -35 C - 65 C11. Input wiring: three-wire system;12. Control mode: 12V/24V compatible;13. Installation method: bolted;14. Wiring is shown in the schematic figure; do not reverse the positive and negative poles to avoid burning the controller. Packing List: 1 x Generator ControllerNote:Please allow slight tolerances in size due to manual measurement, and lighting in photography may result in a difference in color than in real life.