Description Operation steps Insert the screw into the socket corresponding to the buckle (do not tighten it too tightly) and put the buckle on the end of the water pipe. Put the water pipe on the water inlet and outlet of the filter pump and cover it completely as much as possible. After the installation, tighten the screws to fix the water pipe and the main body of the filter pump. After the two water pipes are operated in this way, it is shown in the right figure. The other end of the water pipe shall be sleeved on the water outlet of the swimming pool, the same as the above operation.6.The filter screen needs to be inserted into the water outlet from the inside of the pool to prevent the leaves and hair from entering the inside of the filter pump.Note that the upper interface of the filter pump is the water inlet, which is connected to the lower outlet of the swimming pool; the lower interface of the filter pump is the water outlet, which is connected to the upper outlet of the swimming pool.Specifications Product Name electric filter pumpApplication filtration and cleaningRated voltage 220 v 240 V British gauge, European gauge, 110 V American gaugeRated power 15 WPipe length 105 cmProduct specification 23 23 23 mWeight 4 kgPower cord length 9mPackage Included 1 * water pump, 2 * water pipe, 2 * filter screen, 4 * ring buckle, 4 * screw