Feature:1. Simple operation, practical and convenient, shrimp incubation and feed and view baby fish.2. Facilitate hatching brine shrimp eggs and feed the larvae of ornamental fish.3. It can be installed in the aquarium and incubated at the constant temperature of the aquarium.4. Nontoxic and harmless material, safe for your baby fishes and shrimps.5. Made of high quality plastic material, sturdy, durable and long service life.Specification:Condition: 100% Brand NewItem Type: Shrimp IncubatorMaterial: PlasticColor: As Pictures ShownCapacity: 380mlWeight: Approx. 279gHeight: Approx. 28cm/11.02inchUsing instructions:1. Inject the treated water to the standard water level in the incubator tank, and add about 10g kosher salt to pre-dissolve2. The air pump is connected to the air inlet hole at the bottom of the incubator, and the air volume is adjusted to an appropriate amount. The ideal temperature is 28 ~ 303. Add about 3 to 5 g of shrimp eggs, can hatch smoothly after about 36 ~ 48 hours (depending on the incubation temperature and the quality of shrimp eggs in good harvest)4. Collection operation: after the eggs hatch, stop pumping and let stand for about 10 ~ 15 minutes. When the shrimps sink to the bottom and the shells float, the larvae of shrimps can be collected from the original air inlet (air adjusting valve) at the bottom of the incubator, and then the larvae can be fed5. If you have not eaten shrimp, please store them in the refrigerator. Applicable: dry, frozen shrimp eggs are applicableIncubation steps:1. Add water 300 ml2. Add half teaspoon of sea salt3. Add 1 - 2 tablespoons of shrimp eggs4. Connect air pump to open distributor5. Waiting to hatch6. Turn off the distributor and pull out the tracheaIncubation temperature:Shrimp eggs can hatch in the range of 7-30 , and the incubation speed is accelerated with the increase of temperatureThe preference incubation temperatureis 25-30 .Salinity: Different kinds of shrimp eggs require different salinity when they hatchPlace the eggs in fresh water (available mineral water) for 30-60 minutes before hatching to make the dehydrated eggs fully absorb waterThe eggs were then incubated in artificial seawater with a salinity of 3 percentIt is suggested to use sea salt when modulating artificial seawater, because sea salt contains more kinds of ions, which is beneficial to the larva cracking.Package List:1 x Check Valve1 x Suction Cup Fixed Holder1 x Shrimp IncubatorNote:1. Air supply port at the bottom of shrimp incubator, please adjust the air input. Too much or too little air input will affect the hatching time and survival rate of shrimp eggs. Please adjust the air input by air switch.2. The air supply port at the bottom is connected with a simple check valve, which can effectively prevent water backflow in the incubator.