Automatic Water Level Controller Liquid Pump Controller AC 220V with 3Non Contact Water Level Sensor

Feature:1. Sensors Automation: The water level controller is reliable and when the level of the container is too low, a low level alarm signal from the low level sensor is triggered to trigger the controller to close the relay to start the pump to top up the level. When the level reaches a certain level, the high level sensor sends a signal to trigger the controller to disconnect the relay to automatically stop the pump, at which point the controller can be used to fill or empty the tank.2. Wide Loads Application: The water pump water level controller has a relay dry contact output and can be used for a variety of loads.3. Automatic or Manual: The liquid pump controller is versatile and can control the pump in manual or automatic mode.4. Easy Installation: The water pump controller has low power consumption, small size, and non contact level controller is easy to install and maintain.5. Broad Applications: This water level sensor has a three metre cable length and can be used in a wide range of scenarios.Specification:Item Type: Automatic Water Level ControllerMaterial: ABSProduct Model: XKC C383 3P (Automatic water level control and inlet detection)Input Voltage: AC220V, 50HzWorking Current: Working current 7APower Consumption: 2WSensor: XKC Y26 V non contact liquid level sensorLoad Power:When the supply voltage is 220V: Maximum power 1600W If you need to control the load beyond this limit parameter, please install an intermediate relayAlarm Output: 800W-1600W (resistive load)Output Mode: relay normally open contactSensor Interface Voltage: DC12VWorking environment temperature -20-105C, relative humidity80%Mounting Method: Screw wall mountingSize: Approx. 115 x 115 x 40mm / 4.53 x 4.53 x 1.57in .Package List:1 x Automatic Water Level Controller1 x Screwdriver4 x Screw3 x Cable Tie