new and high quality.Made of high-quality acrylic material, , firm and nonslip to use.Light and accurate, it can bring a good and wonderful calibration effect.It is a useful calibration distance gauge tool to adjust the vinyl records.Side A is used to the side sliding force of the stylus, Side B is used to calibrate the .Easy to use, one sided alignment mat provides a diagram for alignment.How to use:1. Place the calibration disk on the vinyl turntable, move the to the R2 position, align the stylus with the center of the circle or the arc line, and adjust the angle of the so that the front edge of the is level with the horizontal line on the calibration disk.2. Move the to the R1 position, calibrate the angle again, and check whether the front edge of the is level with the horizontal line on the calibration disk.3. Repeat steps 1&2 if necessary. You only need to loosen the screws to move the . After the adjustment is completed, tighten the fixing screws.(Calibrate the R2 point so that the front edge of the is level with the OVER HANG horizontal line on the calibration disk.)Manual measurement, there may be slight errors, which will not affect the useColour:WhiteMaterial: AcrylicSize: Diameter: 300mm, Thickness: 3mmPackage Contents:1 x LP Vinyl Pickup CalibrationOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.