Product Description1. Button 1: fortify1. The direction light flashes once, the horn and the horn beeps once, the lock is turned off, and the flame is turned off. The LED flashes slowly, and each pre is effective, but the second pre does not close the lock.2. If you pre Release within 3 seconds after the system is armed, the horn and horn will beep once, and the vibration sensor will be turned off. Exit when armed again.3. There are ACCs that are locked for defense.2. Button 2: Release1. The direction light flashes twice, the horn and the horn beeps twice, and the lock is unlocked. The LED flashes slowly. If you pre it again, the lock will only be unlocked.2. If there is ACC, pre the release button to unlock.3. Button 3: (Anti-robbing) (programmable) Please refer to the function setting table 81. Anti-grabbing at the side door:Turn on the ACC, if you open and then close the main driving door, the LED flashes and the lights flash twice, indicating that the function is activated. If the sound is set, the horn will beep twice. To enable the anti-robbing function, you must connect the anti-robbing line to the side door negative .2. Remote control anti-robbing:Turn on the ACC, pre the meter key or mute button for 3 seconds, the light flashes twice, the horn and the negative horn beeps twice, and the LED flashes quickly, indicating that the function is on. If the sound is on, the horn beeps twice and the function is programmable. (See function setting table 8)3. Ignition prevention:If this function is turned on, every time you turn on ACC, the system will automatically activate the anti-robbing function. There is no need to open the door. Pre the remote control. After activation, the LED will flash and the car lights will flash twice. If the sound is turned on, the horn will beep twice and the function can be set. (See programming table 10)4. On-site anti-looting:This function is used when the car is driven out, use an additional remote control (except the 2 remote controls) to emergency stop the car, activate within 60 seconds, the LED flashes, the car lights flash 2 times, if the sound is turned on, the horn will sound 2 Second, the function can be set (see the function setting table), so the optional remote control will stop the car 60 seconds after leaving the car.5. Enter anti-robbingThe system enters the anti-robbing mode, the car lights flash twice, if the function 13 is also activated, the horn will beep twice, and the LED starts to flash slowly. After 30 seconds, the car lights flash and the horn shouts. After 15 seconds, if the function 14 is turned on When the sound is turned on, the current cut-off device (relay) will immediately turn on and send a bad working signal to the engine. After 15 seconds, the current cut-off device will activate again, shut off the engine, lock the door, and the horn will keep beeping.6. Exit anti-robbing:Turn off the anti-robbing system before the horn keeps beeping, or pre the emergency contact button once within 60 seconds of the anti-robbing trigger, and then release it.After the horn starts to call, or 60 seconds after the anti-grab is triggered, turn on the ACC, pre the emergency contact and the security code the same number of times (the factory default is 1 time), and then wait 3 seconds to confirm whether it is correct.4. Button 4: Tail box,1. Long pre the trunk or search for 3 seconds to open the trunk.2. Pre the button * and the tail box button at the same time, you will activate channel 3, (see the function setting of channel 3)Five. DeterPre button 1 and button 2 at the same time for 3 seconds to activate the deterrent function. The direction light and the horn flash in negative synchronization, the horn is long beeping, and the flame is turned off for a long time, and the LED flashes slowly. You can only exit by preing release.Six. Mute fortificationPre the button* once, then button 1 once, the system will mute the defense, the direction light flashes once, the lock is turned off, and there is no sound.Seven. Mute and disarmPre button 3 once, then button 2 once, you will disarm in the mute state, the direction light will flash twice, unlock, and there will be no sound.8. For automatic defense (programmable), please refer to the function setting table 1.After the engine is turned off and all doors are closed for 30 seconds, the lights flash once, the horn beeps once, and the LED flashes slowly. If the electric door closing system is set, the doors will automatically close.If the automatic defense is in the car wash mode, it will be automatically cancelled.Nine. Prompt if the door is not closedWhen fortifying, if there is a fault in an area, the horn will beep 3 times and the direction light will flash 3 times, indicating that there is a problem in a certain area, and the side door and tail box are not closed properly.10. Emergency alarmWhen the system is armed, ACC, the side door is opened, or the vibration is re-triggered, the horn is called for a long tim