DC Timer Switch Module 5V-36V Trigger Cycle Delay Timer Switch Turn On Relay Module With LED Display For Motor Light Sole Valves

Features High frequency fast switching on and off: To obtain a high-frequency fast switching on and off circuit, an unlimited number of switching times. You can set different OP, CL, LOP parameters, which are independent of each other and are saved separately. Wide compatibility: Dual MOS active parallel output, lower internal resistance, larger current, high power; at room temperature, the working current is up to 15A, the power up to 400W, which can be used for most equipment. Wide Application Wide voltage input from 5V to 36V, normally used to control DC motors, lights, LED strips, micro pumps, solenoid valves, etc., very convenient. All settings of the settings will be automatically saved in the event of a power failure. DURABLE TO USE Compared with normal electromagnetic relay modules, it has a longer service life. It has an emergency stop function ("STOP" button) and reverse entry protection. Simple operation: no noise was made when power on/off, no sparks and no electromagnetic interference. Automatically enter standby mode and turn off the display if no operation within 5 minutes, and will wake up by pressing any button. Specifications: Voltage: DC 5 V ~ 36 V. Trigger signal source: the high voltage level trigger (3.0V~24V), signal ground and system ground are not on common ground to improve the anti-jamming ability of the system (you can also connect them on common ground). Output capacity: DC 5V~36V, at room temperature, DC current is 15A, power 400W. With improved heat dissipation, the current can reach 30A. Resting current: 20mA. Operating current: 50mA. Operating temperature: -40℃~85℃ Timing range (delay): 0.1second to 999minutes Size: 60*34*12mm/2.36*1.33*0.47" Relay activation mode: 1. ON: the relay allows the conduction in time "OP"; 2. OFF: the relay prohibits conduction and is always closed; In the main interface, press the "STOP" button to switch between ON and OFF, the current state flashes, and then return to the main interface. (This function is an emergency stop function, press the button to disconnect the relay) Standby mode: 1. "C-P" standby mode: five minutes without any operation, the digital display automatically turns off, the program runs as usual; 2. Normal mode "O-d": the digital display always turns on; Hand press the "STOP" button for two seconds to switch between "C-P" and "O-d" states, the current state flashes, and then return to the main interface. Package includes: 1 x Timer Module Package List