Electric matcha tea frother made of steel, easy to handle and with the power button on the top bar The design of this product is very practical and simple but elegant.. This device will allow you to create the perfect froth for matcha tea, milk, cappuccino or hot chocolate. Batteries required: 2 x AAA alkaline batteries (not included). Size: 2.2 x 25.4 cm Product description Electric steel matcha tea frother, easy to handle and with the power button on the top bar. The design of this product is very practical and simple yet elegant. This device will allow you to create the perfect froth for matcha tea, milk, cappuccino or hot chocolate. To better use the frother, read the manual inside the package and follow the instructions. Batteries required: 2 x AAA alkaline batteries (not included). Inserting the batteries 1. Remove the lid which is at the end of the frother handle 2. Insert two AAA batteries into the handle. The positive end (1) must face the tip of the aerator 3. Replace the cover and the screw. ATTENTION! Do not bend the stem or spiral.This would lead to an imbalance prejudicial to the proper functioning of the device. Use 1. Make sure the rod is securely attached to the crankshaft. A loose coupling shaft causes imbalance. If necessary, push in the black plastic casing, so that it is firmly fixed. 2.Pour the milk of your choice into a high-sided glass or jug. The glass should not be more than a third full. When foamed, the volume of milk increases significantly. 3.Immerse the spiral (stem end located) in the milk, so that it is slightly above the bottom of the container. 4. Press the black button at the end of the handle to operate the whip. 5. Slowly move the spiral up and down in the milk until the froth does not reach the desired consistency. The best results are obtained after about 15-20 seconds. Make sure that the spiral does not leave the milk during the operation. 6. Switch off the machine before removing the spiral from the milk. Do not wash the device in a dishwasher and never immerse the whisk body in water! Note: The data is all measured manually, please allow 1-3cm error, due to the difference in light and display, there will be a certain color difference, the actual object received shall prevail.