It is suitable for cold splices and can solve the thermal fusion of multi-purpose fiber cleavers. Fiber Cleaver SKL-6C uses a 16-bit plane in a high-strength blade. It has a longer lifespan with triple attachments for bending, cutting and bare fibers, and automatic rear knife slide. Easy to use. You just need to put a good fiber blanket over the lid. Then push and you can do all the cutting work. Specifications: Fiber Rod Applicable Diameter: 125m. Applicable core quality: single core (0.25 and 0.9mm), 2.5 core 12 core tape wire. Fiber cutting length: 18mm.How to use: 1. Lift the fiber cover ejector rod. Open the clips of the single-core fiber clip. Verify that the blade slider is in the forward position.2. Place the fiber in the groove of the single-core fiber clamp. Align the coated line with the appropriate fiber cut length scale. (For example, if the cut length is 18mm, align the bonding wire to the 18mm position on the scale). Then check if the bare fiber is straight.3. The fibers and chips are very tiny and sharp. If it gets into fingers or eyes, everything can hurt. Therefore, you must be very careful during operation. For safe operation, the operator must wear protective glasses.