for RasPi Board Dual Core 264KB ARM Cortex M0+Processor Flexible Microcontroller Board with SD2SP2 SDLoad SDL Adapter White

Features 1、High Performance: For Pico Boot is a microcontroller board based on the for RasPi RP2040 microcontroller chip. It is designed as a one of a kind, high performance microcontroller board with a flexible digital interface. For Pico Boot features two ARM Cortex M0+ cores up to 133 MHz; 256 kb of RAM; 30 GPIO pins; and a wide range of interface options. 2、Easy to Use: This for SD2SP2 SDLoad SDL adapter allows a Micro storage card to be inserted into serial port 2. Start your for NGC game or backup from the second serial port for lag free full motion video and improved read in of the serial port adapter, for SWISS code improvements allow for better read time as the serial port on the game console, and game loading faster. 3、Multiple Software Support: For Pico has rich and complete software support, it comes with full compatibility with the official for RasPi C/C++ SDK, Micro python SDK. 16MB of on board QSPI flash memory for code and data storage. Maximum operating current is up to 500 mA. 4、Support USB TYPE C Interface: Castellated module allows direct soldering to carrier board, one touch reset button function, quick and easy, low power sleep and hibernate modes, drag and drop programming using mass storage via USB. 5、Rich Hardware Interface: For RasPi Pico has 26 x multi function GPIO pins, 2 x SPI, 2 x I2C, 2 x UART, 3 x 12 bit ADC, 16 x controllable PWM channels, on chip precise clock and timer, temperature sensor, accelerated on chip floating point library, 8 x programmable I/O (PIO) state machine, custom peripheral support. Specification Item Type: for RasPi Microcontroller Board Material: PCBA Size: Approx. 5.1 x 2.1 x 0.4cm/2.0 x 0.8 x 0.2in Interface: USB C Processor: Dual Core Arm Cortex M0+ Processor Chip: for RasPi RP2040 Microcontroller Chip On Board Flash Memory: 16MB Sram: 264K Maximum Operating Current: 500mA for SD2SP2: Micro Storage Card Features Official for RasPi Pico Module Easy to Install, Only 5 Wires Are Needed for Soldering Detailed Soldering Tutorial and Video Instructions Programming Via USB Cable, No Drivers or Programs Required Automatically Launches Any DOL Application of Your Choice (switzerland) Uses the "IPL Injection" Method Which is Superior to Mods Like for XenoGC Complete Replacement for the for XENO+SWISS Boot Disk Method of Operation 26 x Multifunction GPIO Pins 2 x SPI, 2 x I2C, 2 x UART, 3 x 12 Bit ADC, 16 x Controllable PWM Channels Package List 1 x for Picoboot Development Board Copied Program 5 x Electronic Wire 1 x Heat Shrink Tube 1 x Plastic Bracket 1 x Double Sided Adhesive 4 x Silicone Film 1 x for SD2SP2