For Huawei Watch GT 3 46mm JPT-B29 Single Cable LCD Screen with Digitizer Full Assembly About the product 1. Replacement LCD screen and touch screen digitizer assembly for Huawei Watch GT 3 46mm JPT-B29 2. Replace your broken or non-functional screen with a new one 3. Restore your device to a like-new appearance 4. Designed to fit and function properly 5. Each unit is inspected and confirmed in good condition before shipment 6. Professional installation is highly recommended. No responsibility will be taken after the screen has been installed Before Installation Notes Tip 1: Test before installation Do not remove any protective film or labels during testing. Be aware of static electricity. Before starting any repair, ground yourself using an ESD (electrostatic discharge) strap to prevent damage to internal electronic components. Wear eye protection and handle glass components carefully to avoid injury from sharp edges. Tip 2: Perform a test connection Screen replacements are delicate. Testing before full installation is strongly advised. Partially disassemble the device, connect the motherboard to the new LCD/screen via the flex cable, power on the device, and verify proper functionality. If the screen works correctly, proceed with full installation. If there is no display, contact support immediately. Do not force installation if issues occur. No responsibility will be assumed after installation. Tip 3: Avoid excessive cable bending Do not bend the LCD flex cable beyond 90 degrees. Excessive bending may result in display failure or black screen.