LED driver with wireless remote and app control, for AC170245V supply only. This driver does not operate on 110V. Key features and specifications Input: AC 170245V, 50/60Hz. Not compatible with 110V systems. Output: DC 60130V and DC 120200V, constant current 240mA. Power configuration: (2040W) x4 and (4060W) x4. Control: 2.4G RF remote control and mobile app control for flexible operation. Control distance: up to 30 m in open space. Package contents: 1 LED driver and 1 remote control. Why choose this driver Wide input voltage range for use in regions with 170245V mains, reducing the need for additional converters. Dual output ranges and multiple power channels support a variety of LED modules and fixture arrangements. Wireless control via 2.4G RF and app allows convenient on off and dimming control from a distance, simplifying installation and daily operation. Constant current 240mA output helps ensure stable LED performance when used with compatible fixtures. Compatibility and installation notes Use only with LED modules whose voltage and current requirements fall within the listed output ranges and power per channel. Confirm total LED load per channel matches the listed power ranges: 2040W for four channels and 4060W for four channels. Do not connect to 110V mains. Ensure input power meets the AC 170245V requirement before installation. Allow slight manual measurement deviation for physical data. Verify wiring and polarity according to your fixture documentation. Typical applications Linear or strip LED installations in commercial and retail lighting where centralized wireless control is desirable. Architectural accent lighting runs that require multiple channels and stable constant current drive. Display, showroom, or signage lighting where remote or app control and precise dimming improve convenience and presentation. Additional notes The actual product color may vary slightly from images due to monitor and lighting differences. Follow standard electrical practices for installation and verify compatibility with intended LED modules before use.