The new Venturi injector is installed in parallel with the water supply control valve at the entrance of the irrigation system of the irrigation system. When in use, the control valve is closed to form a pressure difference between the front and rear, which can make the water flow through the throat of the Venturi injector. Inside the tube, there is a flow channel guide device, which is designed with two taper nozzles. When pressurized water enters the throat pipe, because the pipe diameter is reduced, the flow velocity increase . When the water flow passes through the inlet pipe opening at the maximum speed, a water jet is generated around the jet water column. In the negative pressure zone, the solution is evenly sucked into the pipeline system from the open bucket for fertilization. When installing, the water flow direction should be consistent with the direction on the injector, otherwise it not normal work. The control valve on the main pipe should be to be adjusted slightly to achieve a proper working state. When installing, make sure that the connection part does not leak, otherwise it affect the normal operation of the injector. Name:Venturi Kit Max suck rate:300-1200 L/H flow rate:9-20 m³/H Working Pressure:0.5 - 9.5bar Feature:Controllable, adjustable fertilization, uniform fertilization Application:Drip irrigation,Sprinkler irrigation Fertilize Colour:As Shown Material:Plastic Size:2 Inch Male Thread Package Contents: 1 * Male Thread Venturi Fertilization Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.