Product name: Crankshaft tool Model: MOZHYUAN-3 Application: Motorcycle crankshaft installation Series: Repair tools Item Type: Tire Repair Tools Features:Comes with 3 socket, M10 M12 ,M14 Color: As Shown Material: Steel Installation method: First smear a thin layer of high temperature butter on the bearing seat of body, and then knock the bearing into body along the outer ring. Remember not to knock to the middle. After the bearing is knocked to , a thick sound be emitted. It's already in place. At this time, put a thin layer of butter on the inner ring of the bearing, insert the crankshaft into the bearing, and use a tool to tighten the nut from the other end while pulling it. When the crankshaft is about to be pulled into place, you should not use too much force. Then apply sealant on and pull the crankshaft into the other half of . After installation, the crankshaft is not in the middle of , and it rotates very tightly or does not rotate at all. At this time, you can use tools such as the eye or feeler gauge to determine which direction the crankshaft is offset, and then use this set of box tools to straighten the crankshaft. Pay attention to the grasp of the strength, not too hard to prevent the bearing clearance from being enlarged. After the rotation is smooth, the installation is complete and the oil seal can be applied. Each is equipped with M10, M12, M14, 3 heads. Suitable for most models Package Contents: 1 set Crankshaft tool Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.