MYCR-250 – plug-in dimmer with smart mode1 pack Plug-in receiver dimmer with on/off dimmer button on receiver. Adjustable between front edge controlled phase dimming and rear edge controlled phase dimming, as well as minimum dimmer level. Works with System Nexa remote controls and transmitters. The system is self-learning, which provides a very simple and flexible installation and full compatibility with other products in System Nexa. Can be extended with various receivers such as twilight relay and motion monitor. - On/Off button on receiver- Smart Mode compatible- Easy installation- Adjustable lowest dimmer level and setting for different types of loads- Compatible with Nexa Bridge Smart Mode With devices that support "Smart Mode", you can save up to 3 different favorite scenarios that are easily activated with a Nexa "Smart Mode" transmitter/remote control. With Smart Mode, you can save up to three different scenarios that are then easily activated with the Smart button (or other Smart Mode transmitter). To select your scenario, press the Smart button once, two, or three times. Turn everything off by holding down the button for a short time. What makes a scenario? With one scenario, you can perform multiple events in succession with only one command, that is, you can turn on, dim, and extinguish any number of devices at once. Let's say you're going to lie down in bed and read. Then you want to turn off the ceiling, dim the window lamp to 50% but at the same time have the bed lamp in 100%. No problem. You set up your devices the way you want them and save them in Scenario 1. Then a press of the Smart button is enough and you have your "lie-in-bed-and-read" scenario. As simple as Specifications:Power source: 220-240 VAC~50HzMax load: 20-250W R/RC | 40-250 W RL | 3-120 W LEDRadio protocol / frequency: System Nexa / 433.92 MHz Range: Up to 30 metersNumer of memory slots: 32 standby power consumption: Under 1 WMetric receiver (B x H x D): 53 x 53 x 58 mmE number: 1710809