USB-C input supporting PD/QC protocols, with a PD/QC handshake voltage of 12V. DC5.5-2.1 input, input range of 7-12V, with the option to use either of the two input circuits. Dual interfaces with USB2.0-A and USB-C outputs, total output can exceed 5A. Equipped with a voltage fine-tuning jumper; when jumped, the output voltage can be increased by approximately 0.2V. Comes with a standard fan; the fan is not necessary for loads below 3A. Standard 3D printed base for desktop protection. The dimensions of the power module are compatible with the for CM4 core board dimensions, Portable, Space-Saving. : If 12V is supported, it attempt to handshake at 9V.To support for 5V5A full load output,a PD charger with a 30W output capacity is required. Specifically,it needs to be capable of outputting 30W at 12V,which is 12V2.5A. Summary: 1. Regardless of whether it's the QC or PD protocol, as long as it supports the 12V3A level,it can achieve a full load output of 5V5.5A or more.Supporting the 12V2.5A level can achieve an output of 5V5A or more. 2. The QC protocol uses the USB-A port,and the standard USB-A port has only one power line and one ground line. Generally, the power be smaller than the USB-C interface (which usually has two power lines). 3. The charger's maximum total power cannot be the sole consideration.It is crucial to focus on how much current can be output at the 12V level.To achieve a 5V5A output,the 12V level must be capable of outputting 2.5A or more current. For example,with 's 30W charger,its 12V level can only output 2A,equivalent to 24W. Therefore,it can only support a 5V4.6A output.In contrast,Green Union's 30W charger supports 12V2.5A, allowing it to support a 5V5.33A output. Note:Do not include the for Raspberry Pi5 and Cable. 5V5A_PD Power Module: PD input, wide voltage input, multiple interfaces. Compatible with for Nano,for NanoPi for Soft Router,for 5. Color:As Shown Material:ABS Package Contents: 1 * Power PD Trigger Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.