Temperature Controller Digital Microcomputer Intelligent Thermostat Protector Switch 1500WUS Plug 110V

Feature: 1. The thermostat has a high brightness digital tube, which can clearly display the readings during the day or night. 2. The shell is made of ABS material, and the ultra thick design increases the mechanical strength, good electrical performance and anti aging. 3. 50 110 celsius ultra wide temperature control range, 0.1 celsius temperature control accuracy, suitable for various temperature environments. 4. Unique waterproof stainless steel probe design, resin sealing treatment, waterproof and no rust. 5. Adopts wiring input and output design, which is more convenient to use, and is used in various industrial control equipment. Specification: Item Type: Temperature Controller Material: ABS Temperature Measuring Probe: NTC10K Sensor Wire Length: Approx. 2m 6.6ft Temperature Measurement Range: 50 110 celsius Temperature Measurement Accuracy: + 0.1 celsius Output Current: less than 10A Support Power: less than 1500W Size: Approx. 147 x 96 x 45mm 5.8 x 3.8 x 1.8in Uses: Widely used in the field of incubation, equipment chassis, air conditioning systems, temperature control protection and other fields How to Use: 1. Set The Temperature Calibration: If The Real time Measured Temperature Is Different From The Actual temperature, press this key to adjust; method: Long press the calibration key to display ADJ and flashing words, press the up and down keys to adjust, then press the enter key to save and exit 2. Set The Stop And Start Temperature: Press the set button once, the stop temperature flashes, press the up and down keys to adjust; press the set button again, the start temperature flashes, press the up and down keys to adjust, press the enter key to save 3. Restore Factory Settings: After power on, press the up and down keys at the same time for more than 3 seconds, after displaying 888, the recovery is successful; when LLL is displayed, it means that the temperature sensor is not plugged in, disconnected, or damaged, just replace it; when HHH is displayed, it means it exceeds 110 celsius measuring range, or the sensor is short circuited, the sensor needs to be replaced. . Package List: 1 x Temperature Controller