ZVS BYS459-1500 Induction Heating Module Mini ZVS 5V-12V Module Induction Heating Board for High Frequency Heating

Features ZVS Module Heating Module: ZVS mini finished board has no taps, no heating coil, ignition coil, cooling fan, etc. Tips for Use This hot plate requires some practical ability and related knowledge. Application: Mini version ZVS finished product without induction heating tap for Tes the stepladder drive without cooling fan. Induction heating: when heated, some of the heat generated by the heated object is transmitted to the heating coil. For a long time, the temperature of the heating coil is high. If the heating coil is connected to the terminal, the plastic part of the terminal will melt! Therefore, it is better to solder the heating coil directly to the circuit board during induction heating. Operation Parameters: The maximum power is 120W (12V induction heating). Push the ignition coil to 12V, when the primary 5+5 turns, it is about 30W. Specification: Item type: ZVS induction heating module Model: BYS459-1500 Voltage: 5V-12V Maximum power: 120W Package list: 1 x ZVS Induction Heating Module 1 x For Tes la Coil Note: 1. Mini version ZVS without tap induction heating finished product for step ladder drive without cooling fan. 2. This hotplate requires a certain practical ability and related knowledge. 3. The maximum power of 120W (induction heating 12V). Push the 12V high-voltage package, when the primary 10 turns, about 30W. 4. Input voltage DC 5V~12V, this voltage range is the voltage at work, not the voltage when the power supply is empty! 5. Confirm that all components are properly soldered, the positive and negative poles of the power cord are not reversed, after the load is connected (heating coil, high voltage housing), then turn on! No load can be powered! No-load power is easily damaged! Heating coil 6PCSThe width of the heated object should be between 1/3 and 1/2 of the inner diameter of the heating coil, and the maximum should not exceed 2/3! The object should be checked within 20mm as much as possible. If the heating is too large, it will be difficult to heat up to red. After all, the power is limited. Induction heating usually runs for 5 minutes to turn off cooling. Since the current is relatively large during induction heating, the heat from the coil is also relatively large. Package List 1 x ZVS Induction Heating Module 1 x For Tesla Coil